Summit FF1119B Owner's Manual download pdf (Page 10)

behind the wall). During the compressor's off-cycle, the ice will melt, drip down,

and drain through a small hole behind the crisper into a tray above the

compressor where the compressor's heat evaporates the water.

If you notice an excessive build-up of ice on the rear wall of either the refrigerator

or the freezer compartment, try setting the thermostat to a slightly warmer

setting. Be sure the door gasket is well seated. Occasionally you should check

that there is no obstruction of the drain hole in the bottom rear of the refrigerator

cabinet.

Making Ice Cubes

In the freezer compartment, high-quality ice cubes are formed in about 3 hours.

Once the cubes have been formed, they can be removed from the ice tray by

twisting it gently.

NOTES:

1. Since water expands when it freezes, do not fill the ice tray above the level

of the separation dividers.

2. When using a receptacle other than the supplied ice cube tray to make a

large quantity of ice, you may find that the temperature in the freezer will

rise. This can cause ice cream and other such items to soften temporarily.

3. When ice cubes are stored for an extended period of time, they may

become smaller and stick together.

4. Ice will sometimes develop an off flavor or color if kept too long. To avoid

this, empty the ice tray and make a completely new batch about once a

month.

Hot-Line

With the refrigerator-freezer in operation, it is possible

that the housing will feel warm at the front edges.

This does not indicate trouble. It is attributable to the

hot-line design adopted for this refrigerator-freezer

which consists of piping hot gas from the motor-driven

compressor along the front edges of the housing and

the center partition to prevent moisture from

accumulating. This has nothing to do with the storage

temperature inside.

In the illustration, the dark line indicates the hot-line.

1 2 ... 5 6 7 8 9 10 11 12 13 14

No comments

Summit FF1119B Owner's Manual Page 10