Summit SWC1965 User Manual Page 6

  • Download
  • Add to my manuals
  • Print
  • Page
    / 12
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 5
Technical Data
Model Number SWC1965
Type 2-zone glass door wine cellar
Capacity 160 bottles (15.9 ft
3
)
Electrical Rating 110V AC, 60 Hz
Rated Current 2.0A
Input Power 230W
Power Consumption 438 kWh/yr
Temperature Control Range Upper Zone: 40-50°F; Lower Zone: 50-64°F
Net Weight 221.8 lbs
Gross Weight 251.3 lbs
Unit Size (W×D×H) 23.4" x 26.8" x 69.6"
Installation Instructions
Your SWC1965 wine cellar must not be recessed or built into an enclosure. It must be installed
free-standing, allowing plenty of clearance at the back, sides and top. Be particularly careful to keep
the front of the unit clear of obstructions, especially the vents at the bottom.
Before using your wine cooler:
Remove the exterior and interior packing.
Never lift the unit by the door handle.
Never install or operate the unit behind closed cabinet doors.
Before connecting the appliance to the power source, let it stand upright for approximately 2 hours.
This will reduce the possibility of a malfunction in the cooling system from handling during
transportation.
Clean the interior surface with lukewarm water using a soft cloth.
Place your appliance on a floor that is strong enough to support the appliance when it is fully
loaded.
To level your appliance, adjust the front legs at the bottom of the appliance.
To install the door handle
:
For shipment, the door handle has been stored at the back of the unit. To install the handle, the door
gasket should be gently pulled back where it covers the screw holes for the handle, then the handle
should be attached by screwing it into place with the two screws which are packed in the plastic bag
with this Instruction Manual.
Reversing the door swing
:
As you received your wine cellar, the door swings open at the left. If you wish to reverse the swing so
that the door opens from the right, it is most important to have at least one other person to help.
It is very dangerous to try to reverse the door swing by yourself. Now, unscrew the upper door
hinge while the second person supports the door. Remove the upper hinge and carefully lift the door
off the bottom hinge. Unscrew the bottom hinge and install it on the left side of the unit. Flip the door
around so that the handle is on the right side and slip the door over the bottom hinge. Reattach the
door by screwing the top hinge into the holes provided on the upper left surface of the unit. Make
adjustments as necessary to be sure the door is aligned properly.
- 6 -
Page view 5
1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments