Summit HP P4045 User Manual

HP®P4014 • P4015 • P4045CARTRIDGE REMANUFACTURING INSTRUCTIONSCC364X TONER CARTRIDGECC364A TONER CARTRIDGE3232 West El Segundo Blvd., Los Angeles, Cal

6. Remove the five screws from the left end cap. 7. Remove the right and left side end caps from the cartridge.Note that the gears do not come off the

10. Remove the drum. 11. Remove the PCR.12. Remove the two screws from the wiper blade. 13. Remove the wiper blade from the cartridge and clean outthe

14. Due to the high speed and page counts of these car-tridges, we recommend that the wiper blades be replaced.Make sure that the wiper blade foam sea

19. Install the drum small gear side first onto the drum axlepin20. Install the white plastic drum bushing and screw. If theOEM drum grease is dirty,

23. Note the location of the spring that sits between theMRS holder and the hopper.Remove the two screws, spring and the holder.24. Remove the MRS ass

25. Remove the two doctor blade screws and the doctor blade. Note the clear plastic strip that covers the DB screws. Slide thescrewdriver under the st

28. Note also the new heavy duty style magnetic roller contact.This when combined with the new larger diameter of the roller,allow the cartridge to ru

30. Unlike the HP-4300 series where there are three separatemixing blades in the toner hopper. These cartridges just useone large mixing blade inside

34. Remove the right side small bushing from the magneticroller sleeve and install it onto the holder. Make sure the tabon the bushing aligns with the

36. Install the MRS drive gear. 37. Install the keyed MRS cover. Make sure that the keyed holein the cover matches the keyed end of the magnet in the

First introduced in April 2008, the HP LaserJet P4014 engine is a 45-62 ppm (depending on the model), 1200 dpi engine. Theseprinters will most likely

40. Install the right side end cap and five screws. 41. Install the remaining three screws on the left end cap.42. Install the spring into the drum co

44. Install the arm onto the cartridge. Pull the arm fully backto release the spring from the notch. Check to make sure thedrum cover operates properl

UNINET IMAGING INC. • BROTHER 1240/1650 • ASSEMBLING THE TONER CARTRIDGEUNINET IMAGING INC. • BROTHER 1240/1650 • DISASSEMBLING THE TONER CARTRIDGEH

Right side of 64A Right side of 64XLeft side of 64A Left side of 64XUNINET IMAGING INC. • BROTHER 1240/1650 • ASSEMBLING THE TONER CARTRIDGEUNINET IM

UNINET IMAGING INC. • BROTHER 1240/1650 • ASSEMBLING THE TONER CARTRIDGEUNINET IMAGING INC. • BROTHER 1240/1650 • DISASSEMBLING THE TONER CARTRIDGEH

In the first step, the Primary Charge roller (PCR) places a uniform negative DC Bias voltage on the OPC drum surface. The amountof the negative DC Bia

The third step (developing block) is where the toner image is developed on the drum by the developing section, (or supply cham-ber), which contains th

In the sixth step (fusing block) the image is then fused on to the paper by the fuser assembly, which is comprised of the upperfixing film assembly an

REQUIRED TOOLS1. Toner approved vacuum2. A small common screwdriver 3. A Phillips head screwdriver 4. Needle nose pliersSUPPLIES NEEDED1. Dedicated P4

1. Place the cartridge with the toner hopper facing up andtowards you. This will orient the cartridge for right and leftsides.2. Open the drum cover t