Summit SCR1150 User Manual download pdf (Page 7)

INSTALLATION INSTRUCTIONS

BEFORE USING YOUR APPLIANCE

● Remove the exterior and interior packing.

● Before connecting the appliance to the power source, let it stand upright for approximately

2 hours. This will reduce the possibility of a malfunction in the cooling system from hand-

ling during transportation.

● Clean the interior surface with lukewarm water using a soft cloth.

INSTALLATION OF YOUR APPLIANCE

● Install the refrigerator in a dry place that is not exposed to direct sunlight or any other

source of heat.

● WARNING: Do not store or install the appliance outdoors.

● To allow for door opening, do not install the cabinet against a wall on its hinged side.

● If you want to set the appliance into an enclosure, consider these factors:

- There must be a space of at least 6” above the unit in order to allow the cooling

system to work satisfactorily;

- There must be at least 5/8” clearance between the enclosure wall and the door hinge

to allow for easy opening of the door;

- Allow at least 1” of clearance between the wall and the other side of the appliance.

- Take care that the air vent at the front of the unit is never covered or blocked in any

way.

● Place your refrigerator on a oor that is strong enough to support it when it is fully loaded.

To level the unit, adjust the front leveling legs. When it is moved from a hard oor to a

carpeted surface, allow time for settling into the softer surface, then re-level the unit if

necessary.

● Do not install in a location where the temperature will fall below 60°F (16°C).

● Plug the refrigerator into an exclusive, properly grounded wall outlet. Any questions

concerning power and/or grounding should be directed toward a certied electrician or an

authorized service center.

1 2 3 4 5 6 7 8 9 10 11 12 ... 31 32

No comments

Summit SCR1150 User Manual Page 7