Summit FF1118W Manual download pdf (Page 9)

Operating Your Refrigerator

Setting the Temperature Controls

Your unit has one control for regulating the temperature in the refrigerator

compartment and a separate one for the freezer.

Refrigerator:

The refrigerator compartment's temperature control (thermostat) is a dial type

located at the top center of the compartment.

•

When you turn the unit on for the first time, set the control to its coldest setting,

which is

MAX

• After several hours, adjust the temperature control to the setting that best suits

your needs. The setting MED should be appropriate for most uses.

Freezer:

The temperature control for the freezer is a slide switch located on the back wall

of the compartment. It has settings of WARM, MED and COLD. When first

turning on the unit, set this switch to COLD, then after a few hours, slide it back

to MED.

NOTES:

1. To completely turn off the unit, disconnect the power.

2. If the unit is unplugged, has lost power, or is turned off, you must wait 3 to 5

minutes before restarting it. If you attempt to restart before this time delay,

the unit will not start.

Frost-Free Defrost System

It is not necessary for you to defrost either the refrigerator or the freezer

compartment of this appliance. While the compressor is operating, ice may build

up along the cold rear wall of the refrigerator compartment (the evaporator is

KNOB

BOTTOM VIEW

TURN KNOB

WARM ——————— MED ———————— COLD

FREEZER TEMP. CONTROL

1 2 3 4 5 6 7 8 9 10 11 12 13 14

No comments

Summit FF1118W Manual Page 9