3
To prevent accidental injury, the cord should be secured behind the refrigerator and not left exposed or
dangling.
Never unplug the refrigerator by pulling the power cord. Always grip the plug firmly and pull straight out
from the receptacle.
Do not use an extension cord with this appliance. If the power cord is too short, have a qualified electrician
or service technician install an outlet near the appliance. Use of an extension cord can negatively affect the
performance of the unit.
Installation Instructions
Installation Location
When selecting a position for your Fridge/Freezer you should make sure the floor is flat and firm, and
the room is well ventilated. Avoid locating your appliance near a heat source, e.g. oven, heater or
radiator. Also avoid direct sunlight. If you are placing your appliance in an outside building such as a
garage or annex, ensure that the Fridge/Freezer is placed on a platform above the floor, otherwise
condensation will occur on the appliance cabinet. Never place the Fridge/Freezer in a wall recess or
into fitted cabinets or furniture. When your appliance is working, the grille at the back may become hot
and the sides warm. Therefore, the back part of the refrigerator / freezer must be installed at least
4”from the wall; leave a similar space on both sides. Do not drape any covering over the
Fridge/Freezer.
Leveling the Fridge/Freezer
If the Fridge/Freezer is not level, the door and magnetic seal alignment will be
affected and may cause your appliance to work incorrectly. Once the
Fridge/Freezer is placed in its final location, adjust the leveling feet at the front
by turning them.
Cleaning before use
Wipe the inside of the Fridge/Freezer with a weak solution of bicarbonate of soda. Then rinse with
warm water using a damp sponge or cloth. Wash the baskets and shelves in warm soapy water and dry
completely before replacing in the appliance. The external parts of the Fridge/ Freezer can be cleaned
with wax polish. See page 7 for more details on cleaning.
Before plugging in YOU MUST
Check that you have a socket which is compatible with the plug supplied with the appliance. If not, see
the section ELECTRICAL INFORMATION on page 7.
Before switching on!
DO NOT SWITCH ON UNTIL FOUR HOURS AFTER MOVING THE FREEZER.
The coolant fluid needs time to settle. If the appliance is switched off at any time, wait 30 minutes
before switching back on to allow the coolant fluid to settle.
Before filling your Fridge/Freezer
Before storing foods in your appliance, turn the unit on and wait for 24 hours, to make sure it is working
properly and to allow the Fridge/Freezer to fall to the correct temperature. See page 4 for more details.
(12 pages)
(28 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals