DISHWASHER Models DW2432 and DW2432SS Installation Manual Felix Storch, Inc. Summit Appliance Division 770 Garri
6.3.1 INSTALLING THE FOOT SUPPORTS If the height of the enclosure is above 34-1/4” (870mm), use long su
Adjust the front foot level with the adjusting wrench to balance and raise the dishwasher to the enclosure height. Adjust the rear foot level with a
6.5 PREPARING THE WATER CONNECTION (A) Install an easily accessible shut-off valve (not supplied) in the water supply line. All solder connections mu
6.6 DRAIN PREPARATION The dishwasher drain hose may be connected to the drain plumbing in one of three ways (Figures A, B, C). Notice: Us
6.7 STEAM PROTECTION FOIL Steam will form inside the dishwasher during operation. At the end of the cycle, when the dishwasher door is opened, it is
7. PLACEMENT OF DISHWASHER INTO THE OPENING Now place the dishwasher into the opening and get ready to connect all hoses and electrical connections.
7.1.2 WATER SUPPLY CONNECTION Water supply may be connected to the dishwasher in one of two ways: With braided metal hose With copper tubing
Install a strain relief (not supplied) into the opening on the kick plate. (Figure A) Pass the electrical supply cable through the strain reli
7.3 READJUSTING FOOT LEVELS Now that the dishwasher is in the cabinet, you must readjust the feet to bring the dishwasher up to the required height a
Lock the toe kick brackets as shown with the plastic tab in Figure C by pushing the plastic tab on the dishwasher into the teeth of the bracket (C).
To prevent accidents which could cause serious injury or death, as well as machine damage, read these instructions before installation and / or use:
Notice: The installer is responsible for the dishwasher installation. Incorrect installation is not covered by the warranty. 8. INSTA
INTRODUCTION Please read this installation manual and particularly the safety instructions completely and carefully. They will save you time and effor
1.1 INSPECT THE DISHWASHER dishwasher-dedicated, properly grounded electrical circuit with a fuse or breakers rated for 15 amperes. Electrical supply
2. TOOLS THAT MAY BE NEEDED 3. MATERIALS THAT MAY BE NEEDED (Additional materials may be required to comply with local codes) H
4. MATERIALS SUPPLIED 4.1 PARTS SUPPLIED Parts for your dishwasher will come in several plastic bags. Check your parts bags shown to make sure you h
5. DISHWASHER SPECIFICATIONS 5.1 TECHNICAL FEATURES Load capacity 12 place settings Permissible water pressure 4.35
6. ENCLOSURE PREPARATION Notice: For proper dishwasher operation and appearance, ensure that the enclosure has the minimum dimensions shown
6.2 PREPARATION FOR INSTALLING MOUNTING BRACKETS 6.3 ADJUSTING HEIGHT Measure the height of the enclosure.
Comments to this Manuals