Summit 56209 User Manual download pdf (Page 34)

Removing The Sear Station

Burner

To remove the Sear Station Burner

, pull the burner tube toward you. This removes it

from the burner tube notch (7). Then rotate the tube clockwise (8), taking care to rotate

it so that the screw at the end of the tube (9) fits through the notch in the heat shield

opening (10). When the burner tube is free, remove it from the cookbox (11).

A) To reinstall the manifold assembly, reverse steps for “Removing Control Panel” as

previously described.

m CAUTION: The burner openings (12) must be positioned

properly over the valve orifices (13). Make sure the opposite

end of the burner tubes (14) properly align into the slots on

the backside of the cookbox. Check proper assembly before

fastening manifold in place.

m WARNING: After reinstalling the gas lines, they should be

leak checked with a soap and water solution before using

the grill. (See “CHECK FOR GAS LEAKS.”)

◆

mAINTENANcE

Side Burner Grate

Side Burner Cap

Side Burner Ring & Head

Igniter Electrode

Control Knob

Igniter

SIDE BURNER MAINTENANCE

m WARNING: All gas controls and supply valves should be in

the OFF position.

Make sure black wire is connected between the igniter and electrode.

Make sure white wire is connected between the igniter and grounding clip.

Spark should be a white/blue color, not yellow.

A) Igniter wire (1)

B) Ground wire (2)

C) Burner (3)

◆

1 2

7 8

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 107 108

No comments

Summit 56209 User Manual Page 34